Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Humble Owner’s Guide

Ghost Controls keypad and intercom repair in Humble typically runs $165 to $340 installed, depending on whether we’re replacing the keypad face, the control board, or the full unit, and we can usually have it done same day since we keep Ghost Controls-compatible parts on the truck. Most Humble homeowners discover the failure the same way: the gate works fine from the remote, but the keypad goes dead, the intercom crackles, or an entry code that worked last week suddenly opens nothing. You’ll also see it after a hard rain or a power surge, which we’ll get into below.

Call (346) 423-6136

Which Ghost Controls Models This Applies To

This repair work covers the Ghost Controls keypad and intercom units across the AXDP, AXP1, and TSS1 series, along with the wireless keypad kits that ship with most Ghost Controls gate opener packages from 2016 forward. The compatibility gotcha that trips up a lot of Humble owners is this: Ghost Controls changed their keypad wiring protocol between the older 433MHz units and the newer 318MHz versions, so a keypad bought online for the wrong frequency will pair but won’t actually trigger the opener. The model number is printed on a sticker inside the battery compartment, and it’s worth a two-minute check before anyone orders anything. For the intercom side, the Ghost Controls units are wired to the opener’s accessory terminals, and the most common point of failure is the speaker wire connection at the gate post, not the intercom board itself. We stock OEM Ghost Controls parts and select quality aftermarket equivalents where the OEM part has a known short lifespan, and we’ll tell you upfront which one your situation calls for.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad lights up but won’t open the gate. This usually means the keypad is transmitting on a frequency the opener isn’t listening for, or the keypad’s pairing was wiped by a power blink. We see this most often after the spring thunderstorms that roll through Humble.
• Keys stick or don’t register. The membrane on Ghost Controls keypads degrades in Texas heat and humidity, and once the contacts start oxidizing, you’ll get intermittent digits. It’s a parts replacement, not a cleaning.
• Intercom works but the speaker is faint or distorted. This is almost always a corroded connection at the outdoor speaker or a failing capacitor on the intercom board. We can replace the board or rebuild the connection, and we’ll photograph the difference.
• Gate opens randomly without anyone pressing anything. A failing keypad can send a spurious open signal when the internal contacts short. This one is worth a same-day call, because a gate that opens on its own is a genuine security problem, not just an annoyance.
• No power to the keypad at all. It’s either the keypad’s internal battery (on wireless units) or a break in the low-voltage wire running from the opener to the keypad. We ring out the wire before we start swapping parts, so you don’t pay for a keypad when the wire was the problem.

Before

After

Replacement Cost & What’s Included

In Humble, a Ghost Controls keypad swap runs $165 to $230 installed, a keypad and intercom combo runs $240 to $340, and a full replacement of both units with fresh wiring at the gate post runs $300 to $340. The range depends on whether we’re dealing with a wireless keypad or a wired one, whether the intercom board needs replacing versus just re-terminating the speaker wires, and whether the existing mounting post is intact or needs a new bracket. Every price is written and handed to you before we touch a tool, and that’s not negotiable. It’s Haven Standard Clause 1, and it’s why we don’t do verbal estimates. The parts carry their manufacturer warranty, and our labor is covered by the 365-Day Done Right Promise: if the repair isn’t right, we make it right, no argument and no fee, for a full year.

DIY or Call Us?

On a Ghost Controls keypad, there’s one thing an owner can safely check: open the battery compartment on the wireless unit, confirm the batteries aren’t corroded, and confirm the model number sticker is legible. That’s it. The wiring at the opener terminals carries low voltage, so it’s not a shock hazard, but it is a liability hazard: if you miswire the keypad to the opener’s accessory terminals, you can burn the opener’s control board, and that’s a $400 mistake instead of a $200 repair. The intercom side is the same story. If you’ve already checked the batteries and the gate still won’t respond, call us at (346) 423-6136 and we’ll send a tech who’s serviced Ghost Controls gear on driveways from FM 1960 out to Balmoral.

FAQs